Free ground shipping to all US addresses on shop orders over $100!

Email us! retrofit@hidillusionz.com

Call to us: 212-300-5906

Seal It Up:

Retrofit left the back side of your housings a bit open to the elements? These rubber housing caps may be your perfect solution to close that back up for good.

Sizing:

Available in four different diameters to fit the most common headlight flanges: 75/80/90/100mm (internal diameter)

To Measure:

Measure the outer diameter of your headlight’s rear flange and select from the size menu above. If you’re over by +3mm, we recommend going for the next size up and using a large zip tie to secure them.

Durable:

Made of durable black rubber, they wont harden or crack over time through from hot and cold temperature changes. Ribbed inner ridge works to keep them fit snugly to the backside of the housing.

What else?

Well…that’s about it. They’re rubber, they’re housing caps, they keep crud out of your custom headlights. If you have a gap, you probably should order them. That’s all!

Assurance:

We have been doing this for more than a decade. If you are still unsure of what to do, where to go, or just plain have questions, don’t be shy. We are always here to help you in every way that we can and will continue to keep helping out until you fully understand the entire process from start to finish. Remember, we are people too, and everyone starts off the same way with knowing nothing so we completely understand if this is overwhelming for you as we were in the same boat. So contact us and we will get you started towards the right path.

Reviews

There are no reviews yet.

Be the first to review “Rubber Housing Caps”

Related Products

With the years of experience we have gained, you can find examples of our work and positive testimonials from many different car enthusiast forums. Still need more? Check out our gallery and see the many different years, makes, and models we have worked on and still growing!