If you’ve got a ballast out on your Nissan, Infiniti, Acura, or Honda; buying a new OEM replacement certainly is not cheap!
If you’re doing a quad retrofit on a vehicle with factory HID headlights, these will allow you to run a splitter and relay harness off the factory ballast wiring without any splicing.
We’re asking ourselves why we didn’t make these sooner! These convenient adapters allow the use of aftermarket parts in place of expensive Original-Equipment ballasts with zero cutting, splicing, or re-wiring involved.
Made with stranded copper wire, fully sealed male and female connections, and protected with tech-flex mesh in between; these adapters should last longer than your original ballasts did!
Available to fit the OE-side connector on most modern Nissan, Infiniti’s, Acura’s, and Hondas that use Panasonic/Matsushita Gen III or IV ballasts, or Mitsubishi Electric Gen II or III Ballasts.
We have been doing this for more than a decade. If you are still unsure of what to do, where to go, or just plain have questions, don’t be shy. We are always here to help you in every way that we can and will continue to keep helping out until you fully understand the entire process from start to finish. Remember, we are people too, and everyone starts off the same way with knowing nothing so we completely understand if this is overwhelming for you as we were in the same boat. So contact us and we will get you started towards the right path.