Forget about crimp-on wire taps, these convenient “Y” pigtails make splitting or doubling the signals from your headlight system easy and clean.
So you already have a halogen high beam? When retrofitting a bi-xenon projector; you can harness the stock high beam power to activate the bi-xenon solenoid at the same time, thus doubling your high beam output.
Use a splitter to run two low beam harnesses in parallel for four ballasts and then activate two pairs of bi-xenon solenoids off a single high beam output. Three total splitters needed.
Instead of a single low beam and a single high beam, you can retrofit two bi-xenon projectors and split the single high beam output into both projector solenoids. Instant dual low beam dual high beam setup! (generally H7 Male to 9006/9006 female)
For the input, make sure to select the size that matches with your stock high beam bulb type. The output will generally be the female version of that same bulb, coupled with a 9006 to plug into your bi-xenon projector solenoid.
We have been doing this for more than a decade. If you are still unsure of what to do, where to go, or just plain have questions, don’t be shy. We are always here to help you in every way that we can and will continue to keep helping out until you fully understand the entire process from start to finish. Remember, we are people too, and everyone starts off the same way with knowing nothing so we completely understand if this is overwhelming for you as we were in the same boat. So contact us and we will get you started towards the right path.