Free ground shipping to all US addresses on shop orders over $100!

Email us! retrofit@hidillusionz.com

Call to us: 212-300-5906

Got Wires?

Well you’re going to need a way to pass them through the rear-end of your housing without letting moisture in. Here’s your answer!

Easy:

to use! Just bore out a 1-inch hole in the back or bottom of your headlight housing to seat the flanges of the seal into, then feed your wiring through the nipples on the seal.

Silicone:

Each seal is made of a pliable yet durable silicone rubber that wont crack or harden over time. Made to last the life of your headlights!

Four Holes:

Each seal has four holes in it, you can easily run four wires, or stretch to fit two through each hole.

Assurance:

We have been doing this for more than a decade. If you are still unsure of what to do, where to go, or just plain have questions, don’t be shy. We are always here to help you in every way that we can and will continue to keep helping out until you fully understand the entire process from start to finish. Remember, we are people too, and everyone starts off the same way with knowing nothing so we completely understand if this is overwhelming for you as we were in the same boat. So contact us and we will get you started towards the right path.

Reviews

There are no reviews yet.

Be the first to review “4 Position Wiring Seal”

Related Products

With the years of experience we have gained, you can find examples of our work and positive testimonials from many different car enthusiast forums. Still need more? Check out our gallery and see the many different years, makes, and models we have worked on and still growing!